SurfaceLiner™
Multi-Surface Protective Nonwoven

When Installing SurfaceLiner™

• Place plastic-film (glossy-side) upwards to protect against penetration by paints and liquids; Do not pull off the plastic film.
  
  
• Overlap the seams by 2”- 4”. Tape the seams.
  
  
• On full-surface-glue-down installations, the glue must be completely dry and cured. Follow glue manufacturers guidelines on chosen glue for complete curing times.
  
  
• New finishes on hardwood floors must be completely dry and cured. Follow finish manufacturers guidelines on chosen finish for complete curing times.
  
  
• Surface must be totally clean and dry before rolling out SurfaceLiner™. Do not allow any moisture to be trapped underneath.
• Never use on newly laid porous stone or tile floors. Rising moisture could cause stains.
  
  
• Covering up the flooring planks with sheet goods, such as Masonite or plywood, to protect the flooring from damage, while at the same time running the in-floor radiant heat can trap the heat and overheat or “cook” the flooring resulting in damage to the planks. Using the multi-surface SurfaceLiner™ eliminates this problem.